Revitalizant EX120 for gasoline and compressed natural gas (LPG) engines
₾45.00
Tax included
100% Original
XADO Official Georgian Representative
Reinforced revitalizant.
Designed for wear protection and restoring repair of gasoline and natural gas engines, including turbocharged and forced.
It forms on the surfaces of friction pairs cermet coating (engine parts restore their original geometry). As a result a renovated unit exceeds the performance new and guaranteed to serve 2-4 times longer.
Benefits
- Restores and protects friction parts from wear of piston group, crank and gas distributing mechanisms
- Significantly reduces fuel consumption (up to 30% idle)
- Increases to the rated oil pressure in the system
- Aligns and increases compression in cylinders
- Increases engine power, improves acceleration capability
- It reduces noise and vibration by 10 times
- Increases in life span of nodes 2-3
- It protects the engine from the negative effects of "cold start"
- It improves engine operation in 50-100 km
- It allows the engine to operate at emergency oil leakage of up to 300 km
The order of application:
Engine processing is carried out in three stages
- Stage 1 : The contents of the tube to make the engine oil filler neck of the warmed up to operating temperature. Start the engine and let it idle for 5-10 minutes
- Stage 2 : carried out in the same manner by 100-250 kilometers
- Stage 3 : Follow the same procedure through 100-250 km run
The treatment is completed not less than 1500 km of run
Dosage
| The volume of the engine oil system, l. | 3-10 | 11-20 | 21-30 |
|---|---|---|---|
| Number of tubes (9 ml) pieces. | 3 | 6 | 9 |
| Treatment scheme | 1 + 1 + 1 | 2 + 2 + 2 | 3 + 3 + 3 |
| Number of tubes for new engines | 2 | 4 | 6 |
notes
Oil before the end of change is not recommended
can be processed at idling (4 hours - the equivalent of 200 kilometers)
New engines with a mileage of up to 20 000 km to process in one step
Engines after overhaul is recommended to be processed in the usual way in three phases
motors processing liquefied natural gas processing similar to gasoline engines
protective cermet coating is formed on any working mechanism, however, if the mechanism (engine) is in critical condition (wear 100%), it is necessary to replace the damaged parts
Packaging
9 ml Art. XA 10335 tube in blister
XA 10335
Customers who bought this product also bought:
Comments (0)
No customer reviews for the moment.
Reinforced revitalizant.
Designed for wear protection and restoring repair of gasoline and natural gas engines, including turbocharged and forced.
It forms on the surfaces of friction pairs cermet coating (engine parts restore their original geometry). As a result a renovated unit exceeds the performance new and guaranteed to serve 2-4 times longer.