Revitalizant EX120 for cylinders

46,00 ₾

Tax included მიტანის სერვისი 3-4 დღის განმავლობაში

რაოდენობა

გაყიდვაშია

100% Original

Official Georgian Xado Representative

Reinforced revitalizant.

Designed for restoring repair and wear protection of the engine cylinder and piston group without disassembling. It forms on the surfaces of piston assemblies cermet coating. As a result, the cylinder geometry is restored, there is a reduction of the inner diameter, ellipticity disappears.

აღწერა
პროდუქტის დეტალები

Benefits

Increases compression.
It removes scuffs and scratches up to 0,1 mm.
Protect cylinders from wear at cold start.
It reduces noise and vibration.
It increases engine power.
It reduces fuel consumption.
Reduces CO and HC in the exhaust gas.
It enables selective repair (treatment of one or more cylinders).

The application of

Processing cylinder petrol engine

Warm up the engine (the engine should be warm but not hot).
Remove the spark plug and disconnect the central wire of ignition distributor and commutator.
* 1 Write the contents of the tube into the cylinder.
Perform 15-20 piston strokes (scrolling driving wheel, towing and so on. N.).
Tighten the spark plug and start the starter 3-4 times for 3-4 with intervals of 15-20 seconds.
Connect the central wire, switch and start the engine and let it idle for 15 minutes.
Further operation - as usual.

* Making a gel of the tube should be such that the composition falling on the cylinder wall, not the plunger. You can use the medical syringe with a plastic tube, after dissolving the contents of the tube in 5-10 ml of motor oil. In order to avoid water hammer total liquid volume should not exceed 20 ml.

notes

cylinder diesel engine processing is similar to the processing cylinder gasoline engine by introducing a gel-revitalizant through the nozzle orifice or glow plugs.

1 tube - 1 cylinder.

When a cylinder diameter of 120 mm should be double the dosage.